Description
Back Panels
Our range of back panels slot into shelving uprights to join them together and create the back of a shop shelving unit.
The height of back panels required for each shelving bay is 110mm less than the upright height, for example, a 2110mm bay uses a total of 2000mm height of back panels, most effectively achieved by using 5 x 400mm back panels.
Plain back shelving panels can be combined with perforated (pegboard) back panels or Slatwall back panels on the same shelving unit.
Gondola shelving and promo shelving units where both sides are visible require back panels on both the front and the rear.
Our back panels have a tongue and groove edge which increases the rigidity and strength of the shelving bay and are supplied in either jura or silver/9006 colours.
YSF shop shelving back panels can be combined with other 50 pitch system back panels if put at the bottom and look identical when in place.
Available in the following lengths:
500mm
665mm
800mm
1000mm
1250mm
Available in the following heights:
100mm
200mm
300mm
400mm
